Certificat
ISO 9001:2015
Certificat
ISO 14001:2015
Certificat
BS OHSAS 18001:2007

Welded outer bumps, hems, etc.

Welded outer bumps, hems, etc.

Welded outer bumps, hems, column plates and beams, separating sections must have cut angles. The cut openings should be near the edges everywhere, and the corners with radii are preferable in order to ease the continuity of the welds. Round holes are less effective, and if they are used, they should be preferably near the corners. It is advisable to consult the galvanicians about the appropriate drainage openings and their dimensions.

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close